[. . . ] QUICK INSTALLATION GUIDE OF THE SAGEM F@stTM 3000 (H. 323)
13 Internet access Configuration 14 Internet access Configuration (cont. ) 1 Pack - Unit Presentation
Your pack includes the following elements:
2 Setting-up of the filter and connection of the ADSL line
· ·
Enter the parameters delivered by your Internet Access Provider (User Name and Password). [. . . ] Connect as figure here after (at the right moment).
11 Access to your SAGEM F@st (continue)
TM
3000
12 Configure your SAGEM F@st
The welcome screen appears.
TM
3000
· Choose which computer's interface will be used to connect your SAGEM F@stTM 3000: · Ethernet (selection of the network card), · USB (drivers' installation). Remark: If your computer is equipped with an Ethernet card, we advise you to configure by the Ethernet port. · · In the "User Name field", enter root and in the "Password" field, enter 1234. Then click OK to valid.
·
Click the button or select Quick Setup from the list on the left of the screen.
Remark: The bar of the screen shows the equipment's IP address (192. 168. 30. 1). 3
17 Voice over IP (VoIP) Configuration TM of your SAGEM F@st 3000 (cont. )
18 Voice over IP (VoIP) Configuration of TM your SAGEM F@st 3000 (cont. )
· ·
Enter the following parameters: Phone No. , H323 Id. , Codec. Then click the button.
·
In the scroll down list of the "Interface" field, select ppp0 (don't take the reboot invit into account). [. . . ] button to take the Click the parameters entered into account.
20 Voice over IP (VoIP) Configuration of TM your SAGEM F@st 3000 (cont. )
· Select Quick Status from the list on the left of the screen ; the following screen appears.
·
The following screen appears.
·
·
Verify the parameters entered.
·
In normal operation, the Internet Access and VoIP Access status are displayed in green characters respectively "Internet Access enabled" and "VoIP enabled". [. . . ]